kit:acrylic_parts_v007
This is an old revision of the document!
Table of Contents
Acrylic Parts
There are 46 total laser cut acrylic parts in a Crowbox Kit (v007)
Transparent Parts
19 parts cut from transparent acrylic sheet
- 1x Rotor
- 1x Rotor servo horn shoe
- 2x Inner coin slides (formerly shoulders)
- 1x Coin slide
- 2x Coin slide rails
- 1x Basket faceplate
- 1x Basket faceplate rib
- 2x Rail ledger supports
- 2x Rail retainer supports
- 2x Funnel reinforcement
- 4x Coin pushers (Small parts! Two extra provided)
Tinted Parts
1 part cut from blue-tinted transparent acrylic sheet
- Sliding lid for reward basket
Green Parts
9 Parts cut from green colored acrylic sheet
- 1x Body panel - front
- 1x Body panel - rear
- 1x Body panel - left
- 1x Body panel - right
- 1x Body panel - top
- 2x Rail
- 1x Perch pivot bar
- 1x Service door
Ivory Parts
17 parts cut from ivory colored acrylic sheet
- 1x Baseplate
- 4x Reinforcing rings
- 1x Front panel small rib
- 2x Front panel large rib (halves)
- 1x Electronics sled
- 1x Servo support
- 1x Perch
- 2x Coin supports
- 4x Coin magazine panels (front, rear, left, right)
kit/acrylic_parts_v007.1483645210.txt.gz · Last modified: 2017/01/05 11:40 by steve