User Tools

Site Tools


kit:electronics_assembly

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
kit:electronics_assembly [2015/04/28 10:20] – [Required Parts] - Training Circuit stevekit:electronics_assembly [2018/08/01 13:37] (current) – external edit 127.0.0.1
Line 25: Line 25:
  
 ===== Optical Detector Circuit ===== ===== Optical Detector Circuit =====
-This circuit provides power to, and reads the signals from the Crowbox's two reflective **optical sensors**. One of these optical sensors is used to detect the release of a training coin and the other detects coins that have been deposited by birds.+This circuit provides power to, and reads the signals from the CrowBox's two reflective **optical sensors**. One of these optical sensors is used to detect the release of a training coin and the other detects coins that have been deposited by birds.
  
 ==== Required Parts ==== ==== Required Parts ====
Line 32: Line 32:
  
 ====== Ground/Power Busses ====== ====== Ground/Power Busses ======
-How to fabricate and install the copper busses which make it neat and easy to attach and remove Crowbox components from the Crowbox power source.+How to fabricate and install the copper busses which make it neat and easy to attach and remove CrowBox components from the CrowBox power source.
   * +12 VDC    * +12 VDC 
   * 12V GND   * 12V GND
Line 41: Line 41:
  
 ====== Optical Sensor Installation ====== ====== Optical Sensor Installation ======
-This section details how to install and connect the two **TCRT-5000 optical sensors** used by the Crowbox,+This section details how to install and connect the two **TCRT-5000 optical sensors** used by the CrowBox,
  
  
kit/electronics_assembly.txt · Last modified: 2018/08/01 13:37 by 127.0.0.1