User Tools

Site Tools


kit:housing_assembly

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

kit:housing_assembly [2018/08/01 13:37] (current)
Line 1: Line 1:
 +====== Required Tools ======
 +  * Aspergillum (this is a joke)
 +
 +====== Required Supplies ======
 +  * Wood glue
 +
 +====== Assembly ======
 +  -Laminate the two BASE PLATE pieces together to make one thick plate (burned faces inward)
 +  -Laminate the three PERCH ARM pieces together ​
 +    -Assemble and use the PERCH ALIGNMENT TOOL for this.
 +    -Clamp, press, etc. to ensure the PERCH ARM cures straight
 +  -Attach 7RPM COIN MOTOR (and GASKET) to the COIN MOTOR SUPPORT
 +    -Bolt heads must be on the inside (nuts on the motor side)
 +    -M3x8mm machine screw x2
 +    -Black hex nut x2
 +  -Apply traction material (hot glue) to COIN DISPENSE CAM
 +  -Stack these items onto the COIN MOTOR shaft:
 +    -COIN CAM SPACER
 +    -COIN CAM
 +    -COIN CAM SPACER
 +  -Bolt both COIN MOTOR MOUNT pieces to BACK PANEL
 +    -M3x8mm machine screw x2
 +    -Black hex nut x2
 +  -Bolt COIN TUBE PLATFORM to BACK PANEL
 +    -M3x8mm machine screw x1
 +    -Black hex nut x1
 +  -Bolt 2RPM REWARD MOTOR to MACHINE DECK
 +    -Use Gasket!
 +    -Bolt heads must be on top of the deck - nuts on the motor side
 +    -M3x8mm machine screw x2
 +    -Black hex nut x2
 +  -Install reward wheel glide bolts
 +    -Observe ‘triangle’ layout
 +    -M3x8mm machine screw x3
 +    -Black hex nut x3
 +  -Bolt REAR PANEL to BASEPLATE with REAR BUTTRESS, using washers
 +    -M3x12mm machine screw x2
 +    -Black washer x2
 +    -Black hex nut x2
 +  -Sandwich INNER DEPOSIT RAMP between PERCH PIVOT PANELS
 +    -Press-fit, careful with force
 +    -This part is now the PERCH PIVOT
 +    -Bolt PERCH PIVOT assembly to BASEPLATE, using washers
 +      -M3x12mm x4
 +      -Black washer x4
 +      -Black hex nut x4
 +  -Press together LOWER DEPOSIT RAMP assembly
 +  -Bolt LOWER DEPOSIT RAMP to FRONT PANEL
 +    -M3x12mm x2
 +    -Black hex nut x2
 +  -Press together RAMP AND CHUTE assembly
 +  -Bolt RAMP and CHUTE assembly to FRONT PANEL
 +    -Bolt TOP first, and use a washer
 +  -Align and press RAMP into guides on COIN MOTOR MOUNT
 +    -Bolt bottom pair, without washers
 +  -Slot MACHINE DECK
 +  -Bolt MACHINE DECK
 +    -M3x12mm x3
 +    -Black washer x3
 +    -Black hex bolt x3
  
kit/housing_assembly.txt · Last modified: 2018/08/01 13:37 (external edit)