Differences

This shows you the differences between two versions of the page.

--- kit:software_configuration [2018/08/01 22:57] – [Step Four: Connect your Arduino UNO board] steve
+++ kit:software_configuration [2018/08/01 23:08] – [Step Four: Connect your Arduino UNO board] steve
@@ Line 8: / Line 8: @@
 If you run into trouble following the instructions on this page, there are a number of places to turn for help:
-  * Arduino - [[https://www.arduino.cc/en/Guide/HomePage|Getting Started with Arduino]]
+  * arduino.cc - [[https://www.arduino.cc/en/Guide/HomePage|Getting Started with Arduino]]
+  * arduino.cc - [[https://www.arduino.cc/en/Guide/ArduinoUno|Arduino UNO Guide]]
   * The community at the [[http://groups.google.com/group/CrowBoxKit|Official CrowBox Google Group]]
@@ Line 42: / Line 43: @@
   -The details of the next step depend on your operating system:
     - Windows
-      - In the Arduino IDE menu, select TOOLS->PORT-> and then look for COM port numbered 3 or higher which is also labeled (Arduino/Genuino Uno) and select it.
+      - In the Arduino IDE menu, select TOOLS->PORT-> and then look for a COM port numbered 3 or higher which is also labeled (Arduino/Genuino Uno) and select it.
       - Examples: **COM6 (Arduino/Genuino Uno)** or **COM3 (Arduino/Genuino Uno)**
     - Mac OSX
-      - In the Arduino IDE menu, select TOOLS->PORT->FIXME
+      - In the Arduino IDE menu, select TOOLS->PORT-> and then select the port named starting with **/dev/tty.usbmodem** or **/dev/tty.usbserial**. The port name will probably end with an unusual alphanumeric string.
     - Linux
+      - We have no instructions for this step at present!
       - If you are familiar with the Arduino IDE on Linux, please contact us on the Google Group to contribute to this section