crowboxwiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Required Tools ======
  * Aspergillum (this is a joke)

====== Required Supplies ======
  * Wood glue

====== Assembly ======
  -Laminate the two BASE PLATE pieces together to make one thick plate (burned faces inward)
  -Laminate the three PERCH ARM pieces together 
    -Assemble and use the PERCH ALIGNMENT TOOL for this.
    -Clamp, press, etc. to ensure the PERCH ARM cures straight
  -Attach 7RPM COIN MOTOR (and GASKET) to the COIN MOTOR SUPPORT
    -Bolt heads must be on the inside (nuts on the motor side)
    -M3x8mm machine screw x2
    -Black hex nut x2
  -Apply traction material (hot glue) to COIN DISPENSE CAM
  -Stack these items onto the COIN MOTOR shaft:
    -COIN CAM SPACER
    -COIN CAM
    -COIN CAM SPACER
  -Bolt both COIN MOTOR MOUNT pieces to BACK PANEL
    -M3x8mm machine screw x2
    -Black hex nut x2
  -Bolt COIN TUBE PLATFORM to BACK PANEL
    -M3x8mm machine screw x1
    -Black hex nut x1
  -Bolt 2RPM REWARD MOTOR to MACHINE DECK
    -Use Gasket!
    -Bolt heads must be on top of the deck - nuts on the motor side
    -M3x8mm machine screw x2
    -Black hex nut x2
  -Install reward wheel glide bolts
    -Observe ‘triangle’ layout
    -M3x8mm machine screw x3
    -Black hex nut x3
  -Bolt REAR PANEL to BASEPLATE with REAR BUTTRESS, using washers
    -M3x12mm machine screw x2
    -Black washer x2
    -Black hex nut x2
  -Sandwich INNER DEPOSIT RAMP between PERCH PIVOT PANELS
    -Press-fit, careful with force
    -This part is now the PERCH PIVOT
    -Bolt PERCH PIVOT assembly to BASEPLATE, using washers
      -M3x12mm x4
      -Black washer x4
      -Black hex nut x4
  -Press together LOWER DEPOSIT RAMP assembly
  -Bolt LOWER DEPOSIT RAMP to FRONT PANEL
    -M3x12mm x2
    -Black hex nut x2
  -Press together RAMP AND CHUTE assembly
  -Bolt RAMP and CHUTE assembly to FRONT PANEL
    -Bolt TOP first, and use a washer
  -Align and press RAMP into guides on COIN MOTOR MOUNT
    -Bolt bottom pair, without washers
  -Slot MACHINE DECK
  -Bolt MACHINE DECK
    -M3x12mm x3
    -Black washer x3
    -Black hex bolt x3