Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision |
kit:crowbox2_v20_bom [2018/09/11 16:26] – [Styrene Housing Parts] - Deprecated the rotor pin wrap steve | kit:crowbox2_v20_bom [2018/09/11 16:43] – [Electronics Parts] - Added dupont gator clips steve |
---|
|1| MG995 Servo | {{:kit:bom:bom_mg995_servo_256.jpg?nolink|}} | \\ **Online shopping search term:** MG995 servo | | |1| MG995 Servo | {{:kit:bom:bom_mg995_servo_256.jpg?nolink|}} | \\ **Online shopping search term:** MG995 servo | |
|asstd| Dupont jumper wires | {{:kit:bom:bom_dupont_ribbon_gen_256.jpg?nolink|}} | Select 10cm length, one set of male-to-male and one set of male-to-female. \\ \\ **Online shopping search term:** 10cm dupont m-m f-m | | |asstd| Dupont jumper wires | {{:kit:bom:bom_dupont_ribbon_gen_256.jpg?nolink|}} | Select 10cm length, one set of male-to-male and one set of male-to-female. \\ \\ **Online shopping search term:** 10cm dupont m-m f-m | |
| |1 set| Dupont male with alligator clip | {{ :kit:bom:bom_dupont_gators.jpg?nolink |}} | Dupont male on one end, alligator clip on the other. \\ \\ **NOTE:** only two alligator clip wires are required. You can make your own by soldering alligator clips to ordinary dupont wires, if you already have the gator clips.\\ \\ **Online shopping search term:** dupont alligator clip | |
|1| 5mm terminal block | {{:kit:bom:bom_5mm_terminal.jpg?nolink|}} | \\ Color may be green or blue- it does not matter which you buy, just be sure to get 5mm pitch. \\ \\ **Online shopping search term:** 5mm terminal block 2p | | |1| 5mm terminal block | {{:kit:bom:bom_5mm_terminal.jpg?nolink|}} | \\ Color may be green or blue- it does not matter which you buy, just be sure to get 5mm pitch. \\ \\ **Online shopping search term:** 5mm terminal block 2p | |
|asstd.| 3mm standoffs | {{ :kit:bom:bom_3mm_standoffs.jpg?nolink |}} | Nylon is recommended but brass is fine. Only three standoffs are required, recommended height is 8mm. \\ \\ **NOTE:** It's possible to cobble together standoffs using M3 screws and multiple nuts. \\ \\ **Online shopping search term:** 3mm standoff kit | | |asstd.| 3mm standoffs | {{ :kit:bom:bom_3mm_standoffs.jpg?nolink |}} | Nylon is recommended but brass is fine. Only three standoffs are required, recommended height is 8mm. \\ \\ **NOTE:** It's possible to cobble together standoffs using M3 screws and multiple nuts. \\ \\ **Online shopping search term:** 3mm standoff kit | |