NOTE The parts need to be recounted since splitting the small ribs in half!

There are 46 total laser cut acrylic parts in a CrowBox Kit (v007)

19 parts cut from transparent acrylic sheet

• 1x Rotor
• 1x Rotor servo horn shoe
• 2x Inner coin slides (formerly shoulders)
• 1x Coin slide
• 2x Coin slide rails
• 1x Basket faceplate
• 2x Basket faceplate rib, halves
• 2x Rail ledger supports
• 2x Rail retainer supports
• 2x Funnel reinforcement
• 4x Coin pushers (Small parts! Two extra provided)

1 part cut from blue-tinted transparent acrylic sheet

• Sliding lid for reward basket

9 Parts cut from green colored acrylic sheet

• 1x Body panel - front
• 1x Body panel - rear
• 1x Body panel - left
• 1x Body panel - right
• 1x Body panel - top
• 2x Rail
• 1x Perch pivot bar
• 1x Service door

17 parts cut from ivory colored acrylic sheet

• 1x Baseplate
• 4x Reinforcing rings
• 2x Front panel small rib, halves
• 2x Front panel large rib, halves
• 1x Electronics sled
• 1x Servo support
• 1x Perch
• 2x Coin supports
• 4x Coin magazine panels (front, rear, left, right)