kit:acrylic_parts_v007
This is an old revision of the document!
Table of Contents
Acrylic Parts Overview
NOTE The parts need to be recounted since splitting the small ribs in half!
There are 46 total laser cut acrylic parts in a Crowbox Kit (v007)
Transparent Parts
19 parts cut from transparent acrylic sheet
- 1x Rotor
- 1x Rotor servo horn shoe
- 2x Inner coin slides (formerly shoulders)
- 1x Coin slide
- 2x Coin slide rails
- 1x Basket faceplate
- 2x Basket faceplate rib, halves
- 2x Rail ledger supports
- 2x Rail retainer supports
- 2x Funnel reinforcement
- 4x Coin pushers (Small parts! Two extra provided)
Tinted Parts
1 part cut from blue-tinted transparent acrylic sheet
- Sliding lid for reward basket
Green Parts
9 Parts cut from green colored acrylic sheet
- 1x Body panel - front
- 1x Body panel - rear
- 1x Body panel - left
- 1x Body panel - right
- 1x Body panel - top
- 2x Rail
- 1x Perch pivot bar
- 1x Service door
Ivory Parts
17 parts cut from ivory colored acrylic sheet
- 1x Baseplate
- 4x Reinforcing rings
- 2x Front panel small rib, halves
- 2x Front panel large rib, halves
- 1x Electronics sled
- 1x Servo support
- 1x Perch
- 2x Coin supports
- 4x Coin magazine panels (front, rear, left, right)
kit/acrylic_parts_v007.1483990198.txt.gz · Last modified: 2017/01/09 11:29 by steve